Start by crossing the two sticks or dowels at perpendicular or 90 degree angles.
Make a Clove Hitch on the vertical stick or dowel near the point where the two sticks cross. This fastens the rope to the stick.
Weave the rope under and over the crossed sticks alternately. To do this, run the rope over the horizontal bar, around behind the vertical bar, then back over the face of the horizontal bar on the left. Tighten snugly, then bring the rope behind the vertical bar and up the right front side of the horizontal bar. Repeat this three or four times, keeping the rope tight.
When you have finished weaving the lashing, then "FRAP" it by wrapping the rope between the poles (in front of the back stick and in back of the front stick), pulling tightly. This tightens the connected poles.
Use to attach a rope to a pole, this knot provide a quick and secure result. It rarely jams, and can in fact suffer from the hitch unrolling under tension if the pole can turn. Often used to start and finish lashings.
With practice, this can be easily tied with one hand - especially useful for sailors!
Tip. If you are in a situation where the clove hitch may unroll, add a couple of half hitches with the running end to the standing end of the knot, turning it into a "Clove Hitch and Two Half Hitches"!
Tip. When pioneering, use the Round turn and two half hitches to start and finish your lashings instead of the Clove Hitch. It won't unroll, and is easier to finish tying off. It just does not look so neat!
